PKR payouts · Pakistan

Paying contractors and suppliers in Pakistan

To pay a contractor in Pakistan, send rupees to their bank account by IBAN or by the mobile number registered as their Raast ID. Glide sends PKR as a send-only currency through a SWIFT partner route. Once the receiving bank gets a successful Raast credit advice, SBP rules require the account to be credited within 20 seconds.

By Glide Research · Last reviewed

Pakistan at a glance

Payment facts for Pakistan
CurrencyPKR (Pakistani Rupee)
What Glide supportsSend only: PKR is converted at payout from a balance you hold
Glide payout railSWIFT (via a payout partner)
Domestic rails on the receiving sideRaast, Raast ID or IBAN
Domestic-leg timingDomestic Raast leg after successful credit advice: within 20 seconds; end-to-end provider estimate governs Source
Domestic limitsConfirm whether the payout uses the recipient's IBAN or their mobile number registered as a Raast ID. Source
FeesTransfer fees are published per rail and quoted with the transfer, before you confirm it.

Availability depends on residency, entity jurisdiction, KYC tier, and live vendor feature flags. Rows marked * are partner-dependent. Corridor list is the same set used by the public FX calculator. Crypto deposits may work before fiat rails are fully enabled for your account.

How the money arrives

A payment to Pakistan has two legs: Glide funds and converts the payout, then the recipient's bank or wallet credits it over a domestic rail. Timings below cover the domestic leg only.

Raast

The State Bank of Pakistan's P2P circular requires a receiving participant to credit the beneficiary account within 20 seconds after it receives a successful credit advice.

Source

Raast ID or IBAN

Raast P2P lets a recipient use a mobile number registered as a Raast ID or an IBAN.

Source

IBAN or Raast ID

Raast person-to-person payments accept either an IBAN or a mobile number registered as a Raast ID. For business records, the IBAN is the better identifier: it matches the bank statement and does not change if the contractor changes phone numbers.

Limits are set per bank

The State Bank of Pakistan lets participants set risk-based Raast upper limits, but not below PKR 200,000 per transaction or the account limit, whichever is lower. That is a domestic-rail rule, not a cross-border sending cap; the quote shows the cap that applies to your payment.

Glide does not hold PKR balances. Contractors are paid in rupees converted at payout.

Before the first payment

  • For a Raast-enabled payout, use the recipient's IBAN or mobile number registered as their Raast ID, as requested by the provider.

    Source

Pakistan payment questions

Paying recipients in Pakistan: FAQs

Can Glide hold PKR?

No. PKR is send-only on Glide: you hold USD or USDC, and the amount is converted to PKR when the payout is made.

What does a payment to Pakistan cost on Glide?

Transfer fees are published per rail and quoted with the transfer, before you confirm it. Conversions are quoted at the mid-market rate, with the cost charged as a visible fee rather than buried in the rate.

Which domestic rail matters after PKR reaches Pakistan?

The State Bank of Pakistan describes Raast as Pakistan's instant payment system for transfers between participating bank accounts.

Does Raast make the whole USA-to-Pakistan transfer instant?

No. The official timing describes the domestic Pakistan payment leg. USD funding, provider screening, conversion, and release occur before that leg, so use the dated provider estimate.

Written by Glide Research. Last reviewed .

Rail, timing and limit data reviewed 2026-08-10 against the linked primary sources.

Run payroll and cross-border payments from one account: hold USDC and 2 currencies, convert close to the mid-market rate, and pay out on local rails instead of paying the wire tax. Solo, or with multisig for teams.

Open a business account